Catler FP 4010 - Manual (Page 13)

13
4. Place the blending leg as deeply as
possible into the bowl and press the
trigger switch to turn the stick mixer on.
The button must be held for the required
duration of operation.
5. Work through the ingredients in the
bowl with a gentle raising and lowering
motion.
6. Switch off the motor by releasing the
trigger switch.
7. Ensure the motor has completely
stopped before lifting the blender out of
the bowl.
8. When processing has fi nished, switch
off at the power outlet and remove the
power plug.
TO DETACH THE BLENDING LEG
Ensure the trigger switch is released, the
power is turned off at power point and the
appliance is unplugged. Hold the motor
body with one hand, and using thumb and
fi nger of the other hand, press on the two
EJECT buttons on either side of the motor
body. Pull the motor body away from the
blending leg to detach.
RECOMMENDATIONS WHEN USING
AS A STICK MIXER
• The stick mixer blends foods and liquids
rapidly, therefore it is easy to over
process. Remember when using the
blending leg to stop the stick mixer and
check food throughout the operation.
• Use caution when blending hot food as
it can splatter.
• The stainless steel blending leg allows
for hot food to be processed directly in
the saucepan. This makes blending soups
and sauces very easy.
• For safety reasons remove saucepan
away from the heat before processing.
• Ensure the body of the appliance and
power cord are kept away from any heat
source.
• When pureeing and blending, cut food
into uniform sizes. This will ensure
smooth and consistent results.
• Warm all liquids to be added to soups
and purees, this will ensure even
blending.
• Do not operate the appliance
continuously for more than 1 minute.
Allow the motor to rest for 1 minute
between each use.
If food becomes lodged around the
processing blade or in the blade guard,
follow the safety instructions below:
1. Release the trigger switch, the power off
at the power outlet and unplug the cord.
2. Use a spatula to carefully dislodge the
food. Do not use fi ngers as the blades are
sharp.
3. After the food has been removed and
blades are clear, plug the appliance back
into the power supply, switch the power
on and continue blending.
ASSEMBLY & OPERATION