12 commissioning, 1 safety information, 2 delivery scope and transport inspection – CASO Germany UltraSonicClean User Manual
Page 25: 3 setup location requirements, Danger, Warning
caso Ultrasonic Cleaner
25
Danger
► Do not operate this device if its power cable or plug is damaged, if it does not work
properly or if it is damaged or has been dropped. If the power cable is damaged, it will
need to be replaced by the manufacturer or his service agency or a similar qualified
person, to avoid any dangers.
► Do not open the housing on the device under any circumstances. There is a danger of
an electrical shock if live connections are touched and the electrical or mechanical
structure is altered. In addition, functional faults on the device can also occur.
12 Commissioning
This chapter provides you with important safety notices during the initial commissioning of
the device. Observe the following notices to avoid dangers and damages:
12.1 Safety information
Warning
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
12.2 Delivery scope and transport inspection
As a rule, the Ultrasonic Cleaner is delivered with the following components:
• Ultrasonic Cleaner
• Plastic Basket
• Watch Stand
• Operating Instructions
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
12.3 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
• The device must be set up on a firm, flat, horizontal and water-resistant surface with
sufficient load-bearing capacity for the device with its content.
• Choose the setup location in such a way that children cannot reach the device.
• The device is not intended to be installed in a wall or a built-in cupboard.
• Do not set up the device in a hot, wet or extremely damp environment or near
flammable material.