CASO Germany MCG 25 chef - Manual (Page 70)

caso MCG 25 Chef (pure white, black) 70
E03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme. Press the Stop button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.
13.3 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Error Possible cause Action
The selected program will
not start.
Device door is not closed Close device door
Power plug is not plugged in Plug in mains plug!
Fuse is not activated Activate fuse
The turntable turns
jerkily.
Dirt between the turntable and
the base of cooking camber
Remove dirt
Dirt on rolling ring
Cooking vessel too large Use different cooking vessel
Food is not sufficiently
defrosted, warmed up or
cooked after preset time
has elapsed.
Incorrectly selected time or
power level Re-set time and power level
Repeat process
The device functions but
the cooking chamber
lighting does not work.
Defective cooking chamber
light. Have Service dept repair
cooking chamber light.
Abnormal noises can be
heard during operation of
microwave.
Food is covered with aluminium
foil
Remove aluminium foil
The cookware contains metal
and sparks are being created
within the cooking chamber
Observe information on
cookware!
The time in the display
field is not correct.
Power failure Re-set time
Attention
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.