5 safety information, 6 delivery scope and transport inspection, 7 unpacking – CASO Germany MCG 25 chef User Manual
Page 50: 8 disposal of the packaging, Warning
caso MCG 25 Chef (pure white, black)
50
9.5 Safety information
Warning
Personal and property damages can occur during commissioning of the device!
Observe the following safety notices to avoid such dangers:
► Packaging materials may not be used for playing. There is a danger of suffocation.
► Transport, unpack and use two persons to set down the device because of the heavy
weight of the device.
9.6 Delivery scope and transport inspection
As a rule, the MCG 25 Chef (pure white, black) Microwave is delivered with the following
components:
•
MCG 25 Chef (pure white, black) Microwave
• Rolling ring
•
Glass turntable
• Baking sheet
• Operating Instructions
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
9.7 Unpacking
To unpack the device, proceed as follows:
•
Remove the device out of the carton and remove the packaging material.
•
Remove the accessories located in the cooking chamber and remove the packaging
material.
•
Remove the red coloured safety adhesive strip on the floor of the cooking chamber.
•
Do not remove the film on the oven ventilation opening!
•
Remove the blue protective film on the device itself.
Please note
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
► Please don’t remove the protective film from the inside of the door (if equipped), since
this makes the cleaning of the device easier.
9.8 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging
materials are selected in accordance with environmentally compatible and recycling-
related points of view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste.