CASO Germany MCG 30 chef - Manual (Page 69)

caso MCG30 Chef (pure white, black) 69

Rotating plate and rolling ring
• The glass turntable must be removed and cleaned occasionally. Wash the plate in a
warm soapy solution or in the dishwasher.
• The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.
• Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.
15 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
15.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
15.2 Fault indications
In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.
Error code Description
E-01 Excessive temperature within cooking chamber
The overheating cut-out terminated the current program at a cooking
chamber temperature of 300°C.
Press the Stop button to acknowledge this fault.
The device can be re-activated after the cool down phase.
E-03 Sensor fault
The device has detected an error on a sensor and has terminated the
current programme.
Press the Stop button to acknowledge this fault.
Please note
► If error messages continue to appear after an extended waiting period and restarting the
device, then the device will need to be sent to Customer Service to be inspected.