Brondell H2O+ Cypress H630 Water Filtration System - Manual (Page 8)

6
Faucet Diverter Type (included)
1. Installing the faucet diverter.
a) Unscrew original aerator (faucet spout tip) from your
water faucet.
b) Connect diverter (with rubber washer) to water faucet by hand tightening
using any of the provided diverter adapters for best fit. If needed, use a
wrench (spanner) or pliers but be careful not to over tighten the connection.
The initial flushed water contains carbon powder and air from the
filter. During flushing of filter, sound will be heard as carbon powder
and air is flushed out. This is not a malfunction, please use the
product as usual after flushing the filter.
Make sure to flush water continuously for at least 10 minutes
before initial use.
It is normal for the dispensed water to have significant white air
bubbles suspended in the water for the first few days of use. This
will go away over time as the air is flushed out of the system.
INSTALLATION
Note: be sure to push tubing firmly all the way into the quick-connectors & use Connection
Tool as needed
Tips
Prior to installation.
a) Remove top cover with both hands.
b) Write filter replacement date on filter change sticker found on top
of each filter. Note: Carbon Block (HF-33) and Composite Plus (HF-31)
filters are 6 month filter life & Nanotrap (HF-32) filter is 1 year filter life.
4. Press the button on top of the unit to dispense water (into your sink) and
let it run for 10 minutes to flush the system and activate the filters.
3. First, turn on cold water faucet. Then, open the faucet diverter switch
to supply main water.
2. Installing the tubing.
a) Remove the gray water inlet plug on back of unit (see page 4).
b) Connect one end of the 1/4” tubing (white)
to the water inlet on the water filter unit.
c) Connect other end of hose to faucet diverter.