Salter Brecknell CS Series Crane - Manual (Page 7)

7
Clearing the Accumulator
1. To clear accumulated weight from the scale, press the RC CLEAR key…
CLr is displayed.
2a). To exit without clearing the accumulator, press the RC CLEAR key
again.
no CLr is briefly displayed and then the scale returns to normal
weighing mode.
OR
2b). To clear the accumulator, press the RC MR key…
CLr is briefly displayed, the accumlator is cleared and then the scale
returns to normal weighing mode.
Changing Unit of Measure
You can change the displayed weight from lb to kg by following these steps:
1. With the scale on, press the RC MR key…
SHIFt is displayed.
2. Press the RC HOLD key…
If the unit is in kg unit of measure, the display will show un=1 briefly,
the lb annunciator lights, and the scale returns to normal weighing
mode with lb as the active unit of measure.
If the unit is in lb unit of measure, the display will show un=0 briefly,
the kg annunciator lights, and the scale returns to normal weighing
mode with kg as the active unit of measure.
Check Number of Overloads
You can check the number of times that the weight applied to the scale has
exceeded the maximum limit (9 divisions over full capacity).
1. With the scale on, press the RC MR key…
SHIFt is displayed.
2. Press the CLEAR key…
OL=XX is displayed. XX being the number of times the scale has
been overloaded.
Viewing Battery Voltage
To see the current battery voltage level, follow these steps:
1. With the scale on, press the RC MR key…
SHIFt is displayed.