Salter Brecknell CS Series Crane - Manual (Page 6)

6
Performing, Viewing and Clearing Weight Accumulation
You can accumulate displayed weight to a memory channel. The minimum
weight that can be accumluated each time is 10 lb / 4 kg. Err 10 will be
displayed if you try to accumulate a weight less than the minimum.
You can view the accumlation data by using the remote control. You can see
the last accumulated weight, the number of weighments accumulated and the
total weight accumlated.
Remember, a new weight cannot be added to the accumulation memory
until the previous weight has been removed from the scale and the
display has dropped to 0.
1. With the scale on and showing 0.0 weight, hang a load greater than the
minimum (10 lb / 4 kg) from the hook…
The gross weight is displayed.
2. To accumulate the weight, press the RC M+ key…
As the weight is accumlated to memory the scale beeps, no 001 is
displayed, then HXXXX is displayed briefly then LXXX.X is displayed.
These displays repeat and then the scale returns to normal weighing
mode with the current weight displayed.
no 001 is the number of accumulations done so far.
The HXXXX is the first four digits of the accumulated weight. LXXX.X
is the last four digits of the accumulated weight. For example, if you
had accumulated 615.5 lbs, the display would show H0000 then
L615.5.
3. Remove the weight from the scale and repeat steps 2 and 3 for each
weighment you want to accumulate.
To View the Accumlated Weight Information
Once you’ve accumlated weight to memory you can view the information by
following these steps:
1. With weight accumulated, press the RC MR key…
SHIFt is displayed.
2. Press the RC M+ key…
The display will continuously cycle through the following information:
The number of accumulated weighments.
The last accumulated weight.
The first four digits of the accumulated weight.
The last four digits of the accumulated weight.
3. Press the RC MR key to cancel the cycling of information and the scale
returns to normal weighing mode.