Salter Brecknell B130 - Manual (Page 19)

14
9.0 Displayed Messages
¯ ¯ ¯ ¯ ¯ ¯ Sca le overloaded
- - - - - -
Too many accumulations or accumulated counts too high
_ _ _ _ _ _ Weight signal is too small
0¯ ¯ ¯ ¯ ¯ The zero point is too high
0_ _ _ _ _ The zero point is too low
EEP.Er0
The EEPROM can’t be accessed
EEP.Er1 The parameters in EEPROM are not same with backup data
EEP.Er2 The setting parameter(s) is not in normal range, or the parameter
has not been set
CAL.Err There is an error in calibration: maybe the loaded weight is too
small or the input weight is not correct.
Ad¯ ¯ ¯ ¯ Input signal of ADC is over max. range
Ad _ _ _ _ Input signal of ADC is below min. range;
CAP
Displaying data relating to capacity
UoL Displaying data relating to voltage
Add The accumulated data
PC.t: Data about piece weight
SPL.PCS Data about sample pieces
uP.PCS Data about upper limit pieces
Lo.PCS Data about lower limit pieces
unLoAd Unload weight on the platter
InP.Ld Input loaded weight’s number
CAL.oN Calibration enable switch is ON
CAL.oFF Calibration enable switch is OFF