Casio XJ-ST155 User Manual
Page 44
44
Simultaneous Wireless LAN Connections with Multiple
Projectors
Problem
Cause and Required Action
Refer to:
Wireless Connection 3 is
running on my computer,
but the Projector List
dialog box won’t display.
z Make sure all of the projectors are turned on. A
projector can be recognized by a computer even if
“USB” is not selected as the projector’s input source.
–
z Make sure that all of the projectors have wireless
adapters connected (page 11).
z If the projectors and computer are far away from each
other or if there is wall or some other physical
impediment between them, move them closer and/or
remove the impediment.
z If a nearby microwave oven, Bluetooth device, or other
device is interfering with the wireless LAN signal,
relocate the interfering device.
The SSID of the projector
I want to connect to is
not included on the
Projector List dialog box.
z Check the “SSID Broadcast” setting of the projector. If
“Disable” is selected, change the setting to “Enable”.
“To configure projector’s
network settings and
wireless LAN connection
settings” (page 35)
z If the projector is off, turn it on.
Even though entering the
login code displayed on
the Wireless standby
screen, I get a “Could not
connect to projector.
Connection has been
terminated.” error.
z If there are two or three projectors, make sure that
each one has a different SSID: casiolpj_default1,
casiolpj_default2, casiolpj_default3.
“To switch between default
SSIDs” (page 30)
z If there are more than three projectors, assign each
one a unique SSID. In this case you can use the
default SSIDs for three of the projectors and configure
security settings for the remainder of the projectors to
assign original SSIDs.