AVer SF2012H series quick guide - Manual (Page 6)

2
1.2 Hardware Installation
Connect the power adapter and connect the IP camera to local network with the Ethernet cable.
1.3 Factory Default
1. Please follow the below instructions if the user name, password, and IP address are lost.
2. First, unplug the power adapter. Then, press the button in the back of IP camera as shown in
figure.
3. Plug in the power adapter and do not release the button during the IP camera booting.
4. It will take around 30 seconds to boot the IP camera.
5. Release the button after the IP camera finishes booting.
6. Reconnect the IP camera with the default IP address (192.168.1.200), user name (admin), and
password (admin).
Reset button