AVer SF0311H-Z10 IP Cam - Manual (Page 10)

6
 Factory Default Reset: This button is hidden in the pinhole. It is used to restore the factory default
settings. If the system still got problems after reboot, user can reset the factory default settings.
- How to restore the device
1. Insert the paper clip or other suitable tool to press the button continuously.
2. Press this button for 5 seconds. Then the device will be reboot automatically and restored to
default settings.
[Note] Restoring the factory default setting will lose the all previous settings included IP address
permanently. User needs to run the IPWizard II to search the device again and configure it to let
the device work properly.
 DI/DO Connector: The Camera provides a terminal block with 4 pins of connectors for DI and DO. The pin
1 is located at the right side of terminal block from rear view
.