AVer EH6216H+ quick guide - Manual (Page 13)

9
QUICK USER GUIDE
4. The hard disk must be formatted before user can use it with DVR unit. Following the below steps to
format the hard disk.
i - Before formatting hard disk, please stop all operations on DVR system.
- While formatting hard disk, the CPU usage will be near to 100% and might slow down
the DVR system response.
a. Click Setup and enter the password
b. Click System → Add
c. Select the hard disk from device list, then click Format button to start formatting.
d. When formatting is done, click OK.
5. Setup the date and time in order to have correct recording time and date. Following the below steps
to setup date and time:
a. Click Setup and enter the password
b. Click System
c. In Time section, click Setting button of System Time.
d. Select the year, moth and date, then, adjust the time.
e. Click OK to save the setting.
6. Connecting the camera.
To connect analog camera:
a. Plug the analog camera video cable into DVR unit.
b. Click Setup and enter the password.
c. Click Camera.
d. Select camera type as Analog Camera.
e. Then, mark Enable to enable the camera.
f. Give a name of camera and enter short description.
g. Adjust the bright, contrast, hue, and saturation of camera.
h. Finally, click OK.
To connect IP camera:
a. Click Setup and enter the password.
b. Click Camera.
c. Select the camera type as IP Camera.
d. And then, enable the camera
e. Click Add IPCam button.
f. Select using Protocol or URL to connect the IP camera. If user chooses the Protocol,
please select mode, video format, resolution, and channel of IP camera. If user
chooses the URL, please enter the complete URL address of IP camera.
g. Enter ID and password if IP camera ’s access authority is required.
h. Finally, click OK.
DVR unit doesn ’t supply the power to connected external device.