Making the connections, Rear panel, Left panel – AVer SPB370 user manual User Manual
Page 7
E-3
English
Deutsch
Français
Italiano
Es
pa
ñol
Č
esky
M
M
a
a
k
k
i
i
n
n
g
g
t
t
h
h
e
e
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
s
s
The ports on the rear, left and right panel of SPB370 enable you to connect the unit to a
computer, graphics display monitor or LCD/DLP projector, TV or other device. Illustrated
below are the ports that are located at the rear and right panel of SPB370 with their
corresponding labels.
Rear Panel
(1) (2)
(6) (7)
(5)
(4)
(3)
RGB
OUTPUT
DC 12V
VIDEO
OUTPUT
S-VIDEO
OUTPUT
DVI-I OUTPUT
USB
SD CARD
Name
Function
(1) DC 12V
Connect the power adapter into this port.
(2) RGB output
Output the signal from the camera, RGB IN port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector.
(3) S-Video output
Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
(4) Video output
(RCA/Composite)
Output the signal from the camera or the captured images
from the memory source on TV or Video equipment.
(5) DVI-I output
Output the signal from the camera, RGB IN port, or the
captured images from the memory source on a VGA/Mac
monitor or LCD/DLP projector with DVI-I interface. If the
display device does not support DVI-I, it can only display
the signal from the camera and the captured images.
(6) USB
Use SPB370 as a USB Camera or Mass Storage to transfer
the captured images from SPB370 memory source to PC.
(7) SD card
Insert the SD card with the label facing up. It can support
16MB~2GB card capacity and only accepts FAT16
formatted card.
Left Panel
(1)
(3)
(2)
LIGHT BOX
MIC IN
VIDEO OUTPU
T
SPB370
TV
RGB
Name
Function
1. MIC IN
Connect a Ф 6.3mm jack microphone into this port.
2. VIDEO OUTPUT Select to output video signal between RGB (RGB & DVI-I) or
TV (Composite Video/S-Video) display output.
3. LIGHT BOX
Turn on/off the
light box.