Autotech 10.998.230K, 232K Shock Therapy Spark Plug Wire Set, Corrado/Passat VR6 & Mk3 VR6 Models - Manual

Phone 949.240.4000 Fax 949.240.0450 32240-E Paseo Adelanto, San Juan Capistrano, CA 92675
A U T O T E C H
Installation Instructions
Part Number: 10.998.230K; 10.998.232K
Description: SHOCK THERAPY® IGNITION WIRES, VR6
Notes:
Since they will obviously not fit within the grooves made for the stock wires, Autotech's
Shock Therapy® wires for VR6 engines use seven "T-clips" to hold the massive 10.4mm
diameter wires in position on the wire guide/engine cover. A self-tapping screw is used to
mount each clip to the cover. No drilling is required.
T-Clip Installation -
Included with your wire set is 7 nylon clips: 6 dual and 1 single. Each is held to the stock
plastic wire guide with a self-tapping screw. The short screws are used in the front engine
bank's clips, the long screws in the rear bank's.
However, always use a long screw to make the hole for the clip. Once the hole is made, you
can select the proper length screw, depending on where the clip is located.
Remove your stock wires ONE-AT-A-TIME, replacing each with a new Shock Therapy® wire
before removing the next wire. This ensures that you maintain proper firing order (correct
coil terminal to plug connection).
Procedure:
1) Using the plug wire tool, remove the connector from one of the three front spark plugs.
2) Remove the wire from the wire guide by pulling gently upwards, and disconnect the wire
from the coil.
3) Now match the length of the old wire to a new
Shock Therapy® wire, and install the new wire.
At this point, wait until the other two wires are in
place before trying to mount any clips. Repeat this
process until all three wires for the front engine-
bank are installed.
www.autotech.com
Plug wire tool engaged on connector end.