Channel Vision A0240 - Manual (Page 7)

6
7
Using the A0240 with the HP-300 and HP-350
The A0240 is the perfect amplifier to use with Channel Vision’s new HomePlug
audio devices. The HP-300 transmitter distributes your audio source through
your home’s electrical wiring and the HP-350 receiver outputs the audio to an
amplifier, such as the A0240.
Speaker Wire
A0240 Bottom View
A0240
HP-350
HP-300
Pin 8 Power +24VDC
Pin 6 Speaker L-
Pin 1 Speaker L+
Pin 4 Power Ground
Pin 2 Audio L+
Pin 7 Speaker R-
Shield Audio Ground
Pin 3 Speaker R+
Pin 5 Audio R+
Amp-Link Pin Out
The A0240 provides a special Amp-Link connection that is intended to be used
with Channel Vision A0302 wall plate. The pin out is provided here for
reference.
Use the remote provided with the HP-350 to
adjust volume levels in the speakers.
V O L
+
V O L -
C H
U M
TE
C
h
an
n
el
T M
V is
o n
i
TM
A 05 12
IR
Receiver
Audio Source
Specifications: (typical at 25 degrees C)
Power input: 110 - 240VAC, 50/60Hz
Output power: 40 Watts/channel RMS into 6 ohms @ <4% THD
Frequency Response: 20-20kHz (+/-3dB)
Signal to Noise Ratio: >85dB
Input Sensitivity:
500mVRMS
Auto On Threshold: 10mVRMS
Specifications subject to change without notice
A-BUS is a registered trademark of LeisureTech Electronics Pty Ltd