Channel Vision A0240 - Manual (Page 4)

4
5
Using the A0240 as a local input amplifier
In addition to increasing power of a distributed audio system, the A0240 can
also be used to interrupt a the whole house audio source and amplify a local
source device. Using the A0240 with the A0302
The A0302 is the perfect complement to Channel Vision’s A0240 amplifier. It
can utilize the Amp-Link connection, which provides a clean way to interrupt
the speaker-level audio from a low-power system and output 35 Watts per
channel to the speakers. This is the perfect way to add power to low-power
distributed audio systems.
B-Speakers powered by
A0240 40Watt Amplifier
Speakers powered by
A0240 40Watt Amplifier
A-Speakers powered by
AB-124 keypad
Set switch to
“SPKRS IN”
Set switch to
“SPKRS IN”
AB-124 keypad
(rear view)
Whole-House
Audio System
Place switch in L/R mode.
Speaker level audio is
converted to line level to drive
the amp. Amplified audio is
returned to the A0302 through
the Amp-Link cable.
Note: Local source audio devices should have a variable audio output. Use
the volume control on the device to change the volume level in the
speakers. Portable music players and TVs are often used as local source
devices.
Place switch in L/R mode.
Speaker level audio is
converted to line level to drive
the amp. Amplified audio is
returned to the A0302 through
the Amp-Link cable.
A0240
Class D
amplifier
A0240
peak
er Le
vel O
tput
S
u
Spea
ker L
evel
utput
O
e
Lin
Leve
l Aud
io Inp
ut
ne
e
Li
L ve
l Aud
io Inp
ut
Adjust trim pots set the
local source input sensitivity
Local Source Audio