Alumax 890 - Manual (Page 8)

G03744439
1-27-06
Page 8 of 9
12
13
14
Close the door and check the clearance with the
strike jamb [P]. If necessary, loosen the set screws [X]
on the top and bottom slide bars and adjust the door
panel [J] to align the strike magnets. When the door
panel is properly aligned, tighten the set screws securely.
Adjust the drip vinyl [U] by sliding it left or
right until it just touches the curb. Trim the vinyl (flush
with the pivot end and notch 1/4" longer than the drip
rail as shown on the strike end).
The drip plug [T] is supplied with a left and right hand
plug together. Break the right and left drip plug apart
and insert the appropriate plug into the high (strike) side
of the drip rail. Discard the unused drip plug. Peel off
the tape backing and carefully press the drip rail [S] to the
door in the marked position.
Cut the drip rail [S] to the length of the bottom rail
minus 11/16". Clean the bottom door rail and the drip rail
thoroughly to ensure proper adhesion. Unroll the double
stick tape [W] and carefully apply it to the back of the drip
rail (do not peel the tape backing yet).
Insert the tapered drip vinyl [U] into the drip rail. Position
the drip rail flush with the bottom and pivot side of the door
panel [M], then raise the strike side until the bottom edge
of the drip vinyl is parallel to the curb [A]. Mark the
location of each end of the drip rail.