Alumax 795 User Manual

Page 10

Page 10 of 10

EPH-N00-06020

1-26-00

- ALL DOORS

Carefully caulk the interior jamb-to-wall

and curb-to-base joints. For appearance, you may
wish to caulk the exterior joints as well. We
recommend you wait twenty-four hours before the
first shower to allow the caulking to cure properly.

Cut four pieces of the larger vinyl [FF] 1/

2" longer than the horizontal opening and trim
the ends on a 45° angle. Install the top exterior
vinyl starting at both ends and working toward
the middle. Be careful not to stretch the vinyl.

Install the top interior vinyl and the two bottom
vinyls in the same way.

The Care and Cleaning of your new Alumax Bath Enclosure. The simplest

and preferred method of cleaning your unit is by washing it with clean water and
drying with a soft cloth. If soil is still present after drying, a non-abrasive cleanser
with a pH of seven to eight may be used. Comet Bathroom Cleaner

has been

tested and is recommended by the Bath Enclosure Manufacturers Association
(BEMA). Do not use scouring pads, sharp instruments, or acid-based cleansers to
clean the unit.

Thank you for choosing an Alumax Bath Enclosure. Please take a moment

to complete and return the enclosed Customer Response Card. The information
you provide helps us improve the quality of our products and provide better
service to you, our customer.