Alumax 738 - Manual (Page 6)

EPH-N00-06002
1-24-97
Page 6 of 8
7
Insert a nylon pivot bushing [M] into the
bottom pivot bracket [D]. Slip the second pivot
bushing over the top pivot pin on the door panel.
Position the door by inserting the bottom pivot pin
into the bottom pivot bracket. Hold the door
vertical and slide the top pivot bracket into the
pivot jamb [C] and over the top pivot pin and pivot
bushing. Secure the top pivot bracket with a #6 x
3/8" truss head screw [E] and a #8-32 x 1/8" Allen
set screw [F].
Attach the interior door handle [R] and the
exterior door handle [S] to the door with two #6-32
x 1 1/4" round head screws [T].
Peel the backing from the A LUMAX decal [U] and
apply it to the inside handle.
9
Your Pivot Door is equipped with a magnetic
catch. Attach the strike jamb [N] to the door.
Close the door so the strike jamb is 7/8" from the
front of the curb [A] and mark the jamb location on
the wall. If the curb is not used, close the door
parallel to the shower sill and mark the jamb
location. Remove the strike jamb from the door,
hold it in the marked location and mark the hole
locations for the mounting screws. Drill the
mounting holes per the instructions in Step #5.
Replace the strike jamb and attach it to the wall
with three #8 x 1 1/2" flat head screws [P].
Close the door and check the clearance with the
strike jamb. If necessary, loosen the set screws
[K] on the top & bottom slide bars and adjust the
door panel to align the magnets. When the door
panel is properly aligned, tighten the set screws
securely.
8