Alumax 350 - Manual (Page 8)

Page 7 of 8
G03711066
6-9-2014
Lift the interior glass panel into position with the
rollers engaging the groove in the header [ F]. Repeat
for the exterior panel. If panels are not parallel to their
respective wall jambs, remove and adjust the rollers up
or down in their slots to compensate.
10
Slide the stainless steel bumper inserts [ U] into the
two soft vinyl jamb bumpers [ V]. Align the slots in the
bumpers with the glass panels and snap the bumpers
downward over the center wall jamb screws [
D] with the
spacers [ E].
12
Locate the nylon bottom guide [ S] in the middle
of the tub track [ A] with the glass panels in the position
shown. With a 7/64" bit, drill two holes into the V-groove
through the mounting holes in the guide. Install the bot-
tom guide with two #6 x 3/8" pan head screws [
T] thru
the drilled holes as shown.
11
INSERT
SCREW &
SPACER
WALL
JAMB
MOLDED
BUMPER