CyberData 930095K - Manual (Page 14)

CyberData Corporation 930095K Operations Guide
Installing the VoIP Ceiling Speaker
Speaker Setup
8
2.2.3 Confirm the IP Address, Test the Audio, and Check the Volume
When the speaker is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch (
Figure 2-4 ) on the speaker face to announce and confirm the speaker’s
IP Address, test that the audio is working, and check the volume.
Figure 2-4. RTFM Switch
To announce a speaker’s current IP address:
1. Press and hold the RTFM switch until it beeps (after one second).
2. Release the switch to hear the IP address announcement, and check the speaker volume.
Note The speaker will announce it's default IP address (192.168.3.10).
CAUTION Pressing and holding the RTFM switch for longer than 20 seconds will restore the
speaker to the factory default settings. See Section 2.6, "Restore the Factory Default Settings" .
RTFM switch