Roubleshooting guide, Symptom possible cause solution – LG WD-65130F User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

roubleshooting guide
Symptom
Possible Cause
Solution
Rnse+
; Crease Care
• Water supply is not adequate in area
• Water supply taps are not completely
open,
• Water inlet hose(s) are kinked,
• The filter of the inlet hose(s) are clogged.
Check another tap in the house.
Fully open tap.
Straighten hose(s).
Check the filter of the inlet hose.
R-eWash
; Time Save
• Drain hose is kinked or clogged.
• The drain filter is clogged.
Clean and straighten the drain hose.
Glean the drain filter.
1000 (800) (650)
•;':;-S00 (600) (500)
-,:--l00 (400) (400)
No Spin
; R nse Hold
• Load is too small.
• Load is out of balance
• The appliance has an imbalance
detection and correction system. If
individual heavy articles are loaded
(ex. bath mat. both robe, etc.) this system
may stop spinning or even interrupt the
spin cycle altogether.
• If the laundry is still too wet at the end of
the cycle, add smaller articles of laundry
to balance the load and repeat the spin
cycle,
Add 1 or 2 similar items to help
balance the load.
Rearrange load to allow proper
spinning
-95'GF>eWFi#i v-Rnse»
--frilO ■: icTime Sev® -;.-0'9iise Cere
-;-irSO
■:-Qdd
'Is the door
1 opened?
Close the door.
^ If "door error' is not released, call for
service.
-::-9i’C -
->60
:;-40 ■
toW
Unplug the power plug and call for
service.
\-^eWadT
-;-fir№f
• Water overfills due to the faulty water
valve,
Close the water tap.
Unplug the power plug.
Ca l for service.
-■;--95'C Wash
::-so
■
;-Tlme Ssve
• Water level sensor has malfunctioned.
-::-1000 -.:.-95'C
:
;
■
300
■
69
v j o o
-.:.-NflSWo
- i - i u
• Over load in motor.
2S