Adding extra rinse cycle, extra rinse – LG WT1201CW User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
USING YOUR WASHING MACHINE 25
Setting RINSE + SPIN, RINSE + SPIN
Select this option to rinse and spin a load separately from a
regular cycle. This can be helpful in preventing fresh stains
from setting in fabrics. You can change spin speed by
pressing SPIN SPEED repeatedly until the desired speed is
selected.
1 Press the POWER button to turn on the washer.
2 Press the
(^)
button until the RINSE+SPIN indicator light
is lit. (The cycle light will turn off.)
3 Press the ( S i s button to start the cycle. The washer will
start automatically.
Setting SPIN ONLY, SPIN ONLY
This button activates the SPIN ONLY cycle to drain and spin.
1 Press the POWER button to turn on the washer.
2 Press the (^) button repeatedly until the SPIN ONLY
indicator light is lit.
3 Press the (
^ button to start the cycle. The washer will
start automatically.
Setting soak, SOAK
Helps remove stains by adding a soak time before the beginning
of the cycle. The cycle time will increase by 30 minutes. The
agitation of the washer will be weaker during a Soak cycle.
O NOTE-----------------------------------------
You cannot select the Soak option during the Tub Clean
cycle.
Saving energy, COLDWASH"^
For maximum efficiency, wash only small loads, (less than 8
lbs.)
rO NOTE-------------------------------------------
Press and hold the COLDWASH™ button for three
seconds to activate or deactivate SIGNAL. SIGNAL is
the melody and button tones.
1 Press
, and press repeatedly until the
desired cycle is selected.
2 Press
(^)
The washer will automatically adjust the cycle
settings.
3 Set any other desired options.
4 Press
rO NOTE------------------------------------------
When you select the COLDWASH™ option, wash time
will be increased up to 10 minutes.
For high wash dfficiency, it is recommended to use
less than 8 pounds.
Adding extra rinse cycle, EXTRA RINSE
You can add an extra rinse cycle to the default rinse cycle.
1 Press
^ and press ^*) repeatedly until the
desired cycle is selected.
2 Press (^.
3 Press the desired option to use the other options.
Skip to step 4 to use the default setting without
changing the options.
4 Press 0*)
i