Casio PX110 - Manual (Page 10)

E-8
404A-E-010B
Playing with Different Tones
Changing the Effect Type
There are four reverb and four chorus types.
1 Turn on the effect you want to change.
2 While holding down the FUNCTION
button, press the REVERB or CHORUS
button to cycle through the effect type
settings as shown below.
[Reverb]
[Chorus]
About DSP
DSP makes it possible to digitally produce complex
acoustic effects.
The DSP is assigned to each tone whenever you turn
on digital piano power.
Turning DSP On and Off
1 While holding down the FUNCTION
button, press one of the keyboard keys
shown below to turn DSP on or off.
Room 1 Room 2 Hall 1 Hall 2
Chorus 1 Chorus 2 Chorus 3 Chorus 4
NOTE
• Under initial default settings, DSP is on for the main
tone, and layer and split are turned off. DSP can be
applied to only one part as shown below.
• You can turn chorus on or off for each main tone,
layer tone, and split tone part.
• You cannot turn reverb on or off for each main tone,
layer tone, and split tone part.
Using the Piano’s Pedals
The digital piano is equipped with two pedal jacks, one
for a damper pedal and one for a soft/sostenuto pedal.
Pedal functions
• Damper Pedal
Pressing the damper pedal while playing will cause
the notes you play to reverberate for a very long
time. When GRAND PIANO 1 or 2 is selected as
the tone, using this pedal causes note to reverberate
just like the pedal on an acoustic grand piano.
• Soft Pedal
Pressing this pedal while playing weakens notes
played on the keyboard after the pedal was pressed,
and makes them sound softer.
• Sostenuto Pedal
Only the notes of the keys that are depressed when
this pedal is pressed are sustained until the pedal
is released.
Off
On
▲
C 1
▲
C 2
▲
C 3
▲
C 4
▲
C 5
▲
C 6
▲
C 7
▲
C 8
Initial Defaults
Layer Tone DSP On
Split Tone DSP On
Main
Tone
On
Off
Off
Layer
Tone
Off
On
Off
Split
Tone
Off
Off
On
SP-3