Craftsman 247.886640 - Manual (Page 13)

To Engage Augers
• To engage the augers and start throwing snow,
squeeze the auger control grip against the left
handle. Release to stop the augers.
Operating Tips
• Allow the engine to warm up for a few minutes as
the engine will not develop full power until it
reaches operating temperature.
A
WARNING: Muffler, engine and surrounding
areas become hot and can cause a burn. Do
not touch.
• For most efficient snow removal, remove snow
immediately after it falls.
• Discharge snow downwind whenever possible.
Slightly overlap each previous swath.
• Set the skid shoes 1/4" below the scraper bar for
normal usage. The skid shoes may be adjusted
upward for hard-packed snow. Adjust downward
when using on gravel or crushed rock.
• Be certain to follow the precautions listed under “To
Stop Engine" to prevent possible freeze-up.
• Clean the snow thrower thoroughly after each use.
Tire Chains
(if equipped)
• Tire chains, if your snow thrower is so equipped,
should be used whenever extra traction is needed.
MAINTENANCE
General Recommendations
• Always observe safety rules when performing any
maintenance.
• The warranty on this snow thrower does not cover
items that have been subjected to operator abuse
or negligence. To receive full value from the
warranty, operator must maintain the snow thrower
as instructed in this manual.
Some adjustments wilt have to be made
periodically to maintain your unit properly.
All adjustments in the Service and Adjustments
section of this manual should be checked at least
once each season.
Follow the maintenance schedule given below.
Periodically check all fasteners and make sure
these are tight.
Customer Responsibilities
r?.®
^ y
¿iP
c3
Da
o
oc
CL
Lubricate pivot points
Clean snow thrower
Clean shave plate
Clean skid shoes
Check V-belts
Check friction wheel
rubber
UJ z
CD z
UJ
Check engine oil
Change engine oil
Check spark plug
Check muffler
Empty fuel system
* Fill in dates as you complete regular service
Check; service if needed
13