Craftsman 247.370160 - Manual (Page 15)

SERVICE AND MAINTENANCE
I
MAINTENANCE
General Recommendations
• Always observe safety rules when performing any maintenance.
• The warranty on this lawn mower does not cover Items that have
been subjected to operator abuse or negligence. To receive full
value from warranty, operator must maintain the lawn mower as
instructed here.
• All adjustments should be checked at least once each season.
• Periodically check all fasteners and make sure these are tight.
A warning
Always stop the motor and disconnect from the power source before
cleaning, lubricating or performing any repairs or maintenance on the
lawn mower.
Lubrication
1. Remove any buildup of grass and leaves on or around the motor
cover (do not use water). Wipe the mower clean with a dry cloth
occasionally.
2. If debris has built up on the underside of the unit, tilt the mower
forward or on its side and scrape it clean with a suitable tool.
IMPORTANT: Do not use a pressure washer or garden hose
to clean your unit. These may cause damage to electric
components, or the electric motor. The use of water will result in
shortened life and reduce serviceability.
Resetting Overload Protection Switch
This mower is equipped with an overload protection switch to prevent
overheating damage to the motor.
If the overload protection switch pops out:
1. Release the motor/blade control handle and do NOT restart the
mower for at least one minute, allowing the electric motor time to
cool.
2. Lubricate the torsion spring and pivot point on the rear discharge
door and side mulch plug periodically with light oil to prevent rust.
See Figure 12.
Deck Care
AWARNING
To reduce the risk of electric shock, do not expose the mower to
water.
1. Release the motor/blade control handle and do NOT restart the
mower for at least 15 minutes to allow the electric motor extra
time to cool.
2. Press the overload protection switch inward to reset.
3. Restart unit.
NOTE: If the overload protection switch pops out repeatedly
during operation or will not remain in when attempting to reset,
contact Sears or another qualified service dealer for repair.
The underside of mower deck should be cleaned after each use as
grass clippings, leaves, dirt and other debris will accumulate. This
accumulation of grass clippings, etc., is undesirable as it will promote
rust and corrosion.
15