Craftsman 247.370160 - Manual (Page 13)

OPERATION
AWARNING
The motor / blade control handle is a safety device. Never attempt to
bypass its operations.
The motor/blade control handle is located on the upper handle of the
mower. See Figure 9. The motor/blade control handle engages and
disengages the motor and blade.
OVERLOAD PROTECTION SWITCH
The mower is equipped with an overload protection switch, located on
the motor/blade control. This overload protection switch may pop out
when too much strain is placed on the motor. Refer to Maintenance &
Adjustments Section to reset this switch.
CORD RESTRAINT
The cord restraint is located on the back of the upper handle, and
when used properly, helps to protect the motor/blade control and
extension cord powering the unit.
CUTTING HEIGHT ADJUSTMENT LEVER
The cutting height adjustment lever is located above the left rear
wheel. To adjust the cutting height, refer to the Assembly Section.
AWARNING
Avoid accidental starting. Make sure you are in the operating position
behind the mower when using it. To avoid serious injury, the operator
and unit should be in a stable position while starting.
Connecting to an Electrical Power Source
AWARNING
This mower should be operated on a 15 or 20 AMP circuit. If you
experience difficulty in starting with a standard 15 AMP fuse or circuit
breaker, contact your nearest Sears or other qualified service dealer.
Do not use a higher rated fuse or breaker without consulting your
power company.
13