Craftsman 247.28902 - Manual (Page 19)

SERVICE AND MAINTENANCE
J
ENGINE MAINTENANCE
Checking the Engine Oil
Only use high quality detergent oil rated with API service classification
SF, SG, SH, or SJ. Select the oil's SAE viscosity grade according to
the expected operating temperature. Follow the chart below.
Although multi-viscosity oils (5W20,10W30, etc.) improve starting
in cold weather, they will result in increased oil consumption when
used above 32°F. Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
Changing Engine Oil
The engine oil should be changed in the first 5 hours and then every
50 hours or once a season. To change the engine oil, proceed as
follows:
1
.
/bolder ■32°F
“-WarmeA
5W20 SAE30
Oil Viscosity Chart
To check the engine oil, proceed as follows:
• Ensure that the tractor is on a level surface.
• Clean the oil fill area of any debris.
1. Remove the dipstick and wipe with a clean cloth.
2. Insert and tighten dipstick.
I engine CFF but still warm, disconnect spark plug wire and
keep it away from spark plug.
2. Remove the oil fill cap/dipstick from the oil fill tube. See Figure 9.
3. Clip the oil drain sleeve (packed with this manual) onto the oil
drain port. Route the opposite end of the sleeve into an appropri­
ate oil collection container with a capacity great enough to collect
the used oil.
4. Remove the oil drain plug. The oil will begin to drain out of the
engine.
5. After the oil has finished draining, replace the oil drain plug and
tighten. Be careful not to overtighten.
6. Remove the oil drain sleeve and store for later use.
7. Refill the engine with new motor oil until the oil level on the
dipstick reads FULL. Replace the oil fill cap/dipstick.
A CAUTION
Used oil is a hazardous waste product. Dispose of used oil properly.
Do not discard with household waste. Check with your local authori­
ties or or contact 1 -800-4-MY-HCME for a list of safe disposal/
recycling facilities.
adding oil, wait one minute and then recheck the oil level.
A CAUTION
Do not overfill. Cverfilling with oil may cause the engine to not start,
hard starting, or engine smoking. If over the FULL mark on the
dipstick, drain oil to reduce oil level to FULL mark on dipstick.
4.
5.
6
.
5. Replace and tighten dipstick.
Install the oil filter by hand until the gasket contacts the oil filter
adapter, then tighten the oil filter 1/2 to 3/4 turns.
Add oil as described above.
Start and run the engine. As the engine warms up, check for oil
leaks.
Stop the engine and check the oil level. It should be at the FULL
mark on the dipstick.
19