Craftsman 917.273060 User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING CHART
PROBLEM
CAUSE
CORRECTION
Loss of power
• Cutting too much grass/loo
fast.
• Set in “Higher Cuf posi-
tion/reduce speed.
• Throttle in “CHOKF position.
• Adjust throttle control.
• Build-up of grass, leaves and
trash under nrtower.
• Clean underside of mower hous
ing.
• Dirty air filter.
• Clean/replace air filter.
• Low oil levet/dirty oil.
• Check (Ml level/change oil.
• Faulty spark plug.
• Clean and regap or change
spark plug.
• Dirty fuel filter.
• Replace fuel filter.
• Stole or dirty fuel.
• Drain fuel tonk and refill with
fresh gasoline.
• Water in fuel.
• Drain fuel tonk and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
• Spark plug wire loose.
• Connect and tighten spark plug
wire.
• Dirty engine air screen/fins.
• Clean engine air screen/fins.
• Dirty/clogged muffler.
• Clean/replace muffler.
• Loose or deimaged wiring.
• Check all wiring.
• Carburetor out of adjustinent.
• See “To Adjust Carburetor“ in
Service and Adjustments
section.
• Engine valves out of adjust
ment.
• Contact an authorized service
center.
Excessive vibration
■ Worn, bent or loose blade.
• Replace blade. Tighten blade
bolt
• Bent blade mandrel.
• Replace blade mandrel.
• Loose/damaged part(s).
• Tighten loose part(s). Replace
damaged parte.
Engine continues to
run vi^n operator
leaves seat w№ at
tachment clutch
engaged
• Faulty operator-safety pres
ence control system.
• Check wiring, switches and con
nections. If not
corrected, contact an authorized
service center/
department.
Poor cut - uneven
• Worn, bent or loose blade.
• Replace blade. Tighten blade
bolt
• Mower deck not lev^.
• Level mower deck.
• Buildup of grass, leaves, ar)d
trash under mower.
• CleEm underside of mower hous
ing.
• Bent blade mandrel.
• Replace blade mandrel.
• Clogged rrtower ded< vent
holes from buildup of
grass, leaves, eind trash
around mandr^s.
• Clean around mandrels to open
vent holes.
Mower blades will not
rotate
• Obstruction in clutch mecha
nism.
• Remove obstruction.
• Wom/damaged mower drive
belt. '
• Replace mower drive belt
33