Craftsman 917.273060 User Manual
Page 32
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TRÔUBLÉSHOOTING CHART
PROBLEM
CAUSE
CORRECTION
Will not start
• Out of fuel.
• Rll fuel tank.
• Engine not “CHOKED* prop
erty.
• See TO START ENGINE" in
Operation section.
• Engine flooded.
• Wait several minutes before
attempting to start.
* Bad spark plug.
• Replace spark plug.
• Dirty air filter.
• Clean/replace air filter.
• Dirty fuel filter.
• Replace fljet filter.
• Water in fuel.
• Drain fuel tank and carburetor,
refill tank with fresh
gasoline and replace fuel filter.
• Loose or damaged wiring.
• Check all wiring.
• Carburetor out of adjustment.
• See To Adjust Carburetor” in
Service and Adjustments
section.
• Engine valves out of adjust
ment.
• Contact an authorized service
center.
Hard to start
• Dirty air filter.
• Clean/replace air filter.
• Bad spark plug.
• Replace spark plug.
• Weak or dead battery.
• Recharge or replace battery.
• Dirty fuel filter.
• Replace fuel filter.
• Stale or dirty fuel.
• Drain fuel tank and refill with
fresh gasoline.
• Loose or damaged wiring.
• Check all wiring.
* Carburetor out of adjustment.
* See ToAdjust Carburetor" in
Senrice aixl Adjustments
section.
* Engine valves out of adjust
ment.
• Contact an authorized service
center.
Engine will not turn
over
• Clutch/brake pedal not
depressed.
• Depress clutch/brake pedal.
• Attachment clutch is engaged.
• E^sengage attachment clutch.
• Weak or dead battery.
• Rediarge or replace battery.
• Blown fuse.
• Replace fuse.
• Corroded battery terminals.
• Clean battery terminals.
• Loose or damaged wiring.
• Check all wiring.
* Faulty Ignition s^tch.
• Check/raplace ignition switch.
• Faulty solenoid or starter.
• Check/raplace solenoid or
starter.
• Faulty operator presence
switch{es).
• Contact an authorized service
center.
Engine clidts but will
• Weak or dead battery.
• Recharge or replace battery.
•lot start
• Corroded battery terminals.
• Clean battery terminals.
• Loose or damaged wiring.
• Check all wiring.
• Faulty solenoid or starter.
• Check/replace solenoid or
starter.
32