Craftsman 917.273060 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are properly inflated (See “PROD
UCT SPECIFICATIONS”). If tires are
over or underinflated, you will not properly
adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position.
• Measure height from bottom of deck
curl to ground level at front comers of
mower. Distance “A” on both sides of
mower should be the same.
• If adjustment is necessary, make adjust
ment on one side of mower only.
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side.
NOTE: Each full turn of adjustment nut
will change mower height about 3/16".
• Recheck measurements after adjusting.
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-
side. If the following front-to-back adjust
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so the
front is approximately 1/8" to 1/2" lower
than the rear when the mower is in its
highest position.
Check acjjustment on right side of tractor.
Measure distance “P directly in front of
and behind the mandrel at bottom edge of
mower housing as shovwi.
• Before making any necessary adjust
ments, check that both front finks are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
• To lower front of mower housing, loosen
nut “G” on both front links an equal
number of turns.
• When distance “P is 1/8" to 1/2* lower
at front than rear, tighten nut “H” against
trunnion on both front links.
• To raise front of mower housing, loosen
nut “H" from trunnion on both front links.
Tighten nut “G” on both front links an
equal number of turns. .
• When distance “P is 1/8" to 1/2" lower
at front than rear, tighten nut “H”
against trunnion on both front links.
NOTE: Each full turn of nut “G” will
change dim. “P by approximately 3/8“.
• Recheck side-to-side adjustment.
Mandrel
Both Front Unks Should be Equal in Length
Nut"H
Trunnion
Nut “G"
Front
Trunnion
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
• Park tractor on a level surface. Engage
parking brake.
• Remove screws from left hand mandrel
cover and remove cover.
• Roll belt over the top of left hand man
drel pulley.
• Remove belt from electric clutch pulley.
• Remove belt from idler pulleys.
• Remove any dirt or grass dippings
which may have accumulated around
mandrels and entire upper deck sur
face.
•
Check primary idler arm and two idlers
to see that they rotate freely.
• Be sure spring is securely hooked to pri
mary idler arm and bolt in mower hous
ing.
24