Craftsman 358.79104 - Manual (Page 9)

1. Loosen the coupler by turning thG
knob counterclockwise.
Coupler
Shipping
protector
LOOSEN
TIGHTEN
Knob
Remove shipping protector from
coupler.
Remove the shaft cap from the
trimmer attachment (if present).
Position locking/release button of
attachment into guide recess of
coupler.
Push the attachment Into the cou­
pler until the locking/release button
snaps into the primary hole.
Before using the unit, tighten the
knob securely by turning clock­
wise.
Coupler Primary Hole
Guide Recess
P t .............i»ari|
Upper Locking/
Shaft
Button
WARNING; Make sure the lock­
ing/release button is locked in the pri­
mary hole and the knob is securely
tightened before operating the unit. All
attachments are designed to be used in
the primary hole unless otherwise
stated in the applicable attachment op­
erator’s manual. Using the wrong hole
could lead to serious injury or damage
to the unit.
For optional attachments, see the AS­
SEMBLY section of the applicable at­
tachment operator's manual.
ATTACHING SHIELD
^WARNING: The shield must be
properly installed. The shield provides
partial protection from the risk of thrown
objects to the operator and others and
is equipped with a line limiter blade
which cuts excess line to the proper
length. The line limiter blade (on under­
side of shield) is sharp and can cut you.
For proper orientation of shield, see
KNOW YOUR TRIMMER illustration in OP­
ERATION section.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes
through hole in bracket.
4. Securely tighten wing nut onto bolt.
ADJUSTING THE HANDLE
^WARNING: When adjusting the
assist handle, be sure it remains above
the safety label and below the mark or
arrow on the shaft.
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an
upright position; retighten wing nut.