Craftsman 486.24515 - Manual (Page 8)

Assemble the front panel over the end of the cart
using six 1/4" X 1/2" hex bolts and 1/4" hex nuts
(SEMS) as shown in figure 4. Leave two hoies open
in the bottom of the panel as shown in figure 4. With
the cart body halves pulled together, tighten the four
bolts in the bottom of the front panel, then tighten the
bolt in each side.
At this time tighten the three bolts on the bottom of
the cart which were assembled In figure 1.
• Assemble the latch stand bracket to the cart using
four 1/4" X 1/2" hex bolts and 1/4" hex nuts (SEMS).
TIGHTEN. See figure 6.
To prevent accidental tipping during the following
assembly procedures, lower the cart to rest upside
down on the top flanges, so that the wheel support is
facing up as shown in figure 7.
Assemble the wheel support to the bottom of the cart
using eight 5/16" x 3/4“ slotted head screws and
5/16* hex nuts (SEMS) as shown in figure 5. Heads of
screws go to the inside of cart. Tighten.