Craftsman 973.114240 - Manual (Page 10)

OPERATION
SWITCH LOCK
See Figure 2 .
The switch trigger can be locked in the OFF position.
This feature can be used to prevent the possibility of
accidental starting when not in use. To lock switch
trigger, place the direction of rotation selector in
center position.
A WARNING: Battery tools are always in operating
condition. Therefore, switch should always be locked
when not in use or carrying at your side.
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The
direction of rotation is controlled by a selector located
above the switch trigger. With the drill held in normal
operating position, the direction of rotation selector
should be positioned to the left of the switch for drilling.
The drilling direction is reversed when the selector is to
the right of the switch. When the selector is in center
position, the switch trigger is locked.
SELECTOR
CAUTION: To prevent gear damage, always allow
chuck to come to a complete stop before changing the
direction of rotation.
To stop, release switch trigger and allow the chuck to
come to a complete stop.
TO INSTALL BATTERY PACK
See Figure 4.
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure
2 .
■ Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack.
See Figure 4.
LATCHES
DEPRESS LATCHES TO
RELEASE BATTERY PACK Fig. 4
■ Make sure the latches on each side of your battery
pack snap in place and battery pack is secured in
drill before beginning operation.
CAUTION: When placing battery pack in your drill,
be sure raised rib inside drill aligns with groove on
battery pack and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components.
TO REMOVE BATTERY PACK
■ Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure
2 .
■ Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 4.
■ Remove battery pack from your drill.
10