Troubleshooting points – Craftsman 917.252560 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING POINTS
PROBLEM
CAUSE
CORRECTION
Wlii not start
1, Out of fuel,
2 - Engine not "CHOKE D" properly
3,
Engine ftooded.
4,
Bad sparkplug
Dirty air filter
6- Dirty fuel filter
7. Water In fuel
8 - Loose or damaged wiring
9
Carburetor out of adjustment
10, Engine valves out of adjustment,.
1
Fili fuel tank.
2
See 'TO START ENGINE" in Operation section,
3. Walt several minutes before attempting to start,
4
Replace spark plug,
5
Clean/repiace air filter
6
Replace fuei filter
7
Drain fuel tank and carburetor, refill tank with fresh
gasoline and replace fuel filter
8.
Check all wiring
9.
Contact ari authorized service center/department.
10- Contact an authorized service center/department.
Hard to start
1 Dirty air filter,
2.
Bad spark plug.
3.
Weak or dead battery
4.
Dirty fueHiiter
5.
Stale or dirty fuel.
6.
Loose or damaged wiring
7 - Carburetor out of adjustment
0. Engine valves out of adjustment,
1
Clean/repiace air filter
2
Replace spark plug
3
Recharge or replace battery
4
Replace fuel filter.
5. Drain fuel tank and refill with fresh gasolina..
6
Check all wiring
7
Contact ari authorized service center/department,
8
Contact an aiithorizad service center/department.
Engine will not turn over
1, ClutcWbrake pedal not depressed.
2 Attachment dutch is e ngaged,
3,
Weak or dead battery
4,
Blown fuse,
5,
Corroded battery terminais-
S Loose or damaged wiring
7,
Faulty ignition switch
8,
Faulty solenoid or starts r,
9 Faulty operator presence swi tch(es|
1
Depress clutch/brake pedal,
2
Disengage attachment dutch
3
Recharge or replace battery
4
Replace fuss.
5
Clean battary terminals
6. Check all wiring
7 Check/replaca ignition switch
8.
Check/replaca soianoid or starter
9,
Contact an authorized service center/department-
Engine dicks but will not
1
-
Weak
Of
dead battery
,
1 Recharge or replace battery
start
2- Corroded battery terminals.
3- Loose or damaged wiring
4. Faulty solenoid or starter.
2
Clean battery terminals
3
Check alt wiring,
4
Check/replace solenoid or starter
Loss of power
1
.
Cutting loo much grass/too fast
2
Throttie in “CHOKE" position
3
Build-up of f rasSi leaves and trash under mower
4
Dirty air filter,
5,
Low
Oil
ievsi/dirty oil.
6,
Faulty Spark plug
7 Dirty fuel filter
6 Stale or dirty fuel,
9 Water In fuel
10
Spark plug wire loose
1
1
Dirty engine air screen/fins
,
12. Dirly/dogged muffler,
1
3- Loose or damaged wiring
14
Carburetor out of adjustment,
15
Engine valves out of adjustment.
1
Set In "Higher Cut" positlon/reduce spaed
2
Adjust throttle control,
3
Clean underside of mower housing
,
4
,
Ctean/replace air filter,
5
Check oil level/change oil.
6
Clean and regap or change spark plug
.
7
Replace fuel fitte r,
8
,
Drain fuel tank and refill with fresh gasoline
9 Drain fuei tank and carburetor, refill tank with fresh
gasoline and replacB fuel filter,
10,
Connect and tighten spark plug wire.
11
,
Clean engine air screen/flns
,
12,
CJean/replacB muffler
13,
Check all wiring
.
14
Contact an authorized service center/department.
15
Contact an authorized service center/department.
Excessive vibration
1,
Worn, bent or loose biada,
2,
Bent blade mandrel.
3 Loose/damaged part(s)
1
,
Replace blade
.
Tighten biade bolt.
2 Replace biada mandreS
3. Tighten loose pari(s) Replace damaged parts.
26