Craftsman 917.252560 - Manual (Page 10)

ASSEMBLY
INSTALL MULCHER PLATE
(See Figs. 6A St 6B)
* Install two latch hooks to mulcher plate using screw,
washer, lock washer, and weld nut as shown.
NOTE: Pre-assemble weld nut to latch hook by inserting
weld nut from the top with hook pointing down.
® Tighten hardware securely.
“ Raise and hold deflector shield in upright position.
a Place front of mulcher plate over front of mower deck
opening and slide into place, as shown,,
‘ Hook front latch into hole on front of mower deck,
■> Hook rear latch into hole on back of mower deck.
CAUTION; Do not remove discharge
n. guard from mower. Raise and hold
guard when attaching mulcher plate
C- ) and allow it to rest on plate while in
.... operation.
TO CONVERT TO BAOGING OR
DISCHARGING
Simply remove mulcher plate and store in a safe place.
Your mower is now ready for discharging or installation of
optional grass catcher accessory.
/CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE
THE BEST PERFORMANCE AND SATISFACTION FROM
THIS QUALITY PRODUCT,
PLEASE REVIEW THE FOLLOWING CHECKLIST:
/ AI! assembly instructions have been completed.
/ No remaining loose parts in carton.
/ Battery is properly prepared and charged. (Minimum
1 hour at 6 amps),
/ Seat is adjusted comfortably and tightened securely,
/ All tires are properly inflated. (For shipping purposes,
the tires were overinflated at the facloiV).
/ Be sure mower deck is properly leveled side-to-s1de/
front-to-rear for best cutting results. (Tires must be
properly inflated for leveling),
/ Check mower and drive belts. Be sure they are routed
properly around pulleys and inside all belt keepers.
/ Check wiring. See that all connections are still secure
and wires are properly clamped.
WHILELEARNING HOWTO USE YOUR TRACTOR, PAY
EXTRA ATTENTION TO THE FOLLOWING IMPORTANT
ITEMS:
V Engine oil is at proper level.
V Fuel tank is tilled with fresh, clean, regular unleaded
gasoline.
/ Become familiar with all controls - their location and
function. Operate them before you start the engine.
/ Be sure brake system is in safe operating condition.
10