Craftsman 917.292402 - Manual (Page 10)

Spark Plug
Choke
Control
—Throttle
Control
Recoil
Starter
BREAKING IN YOUR TILLER
Break-in your be)t(s). pulley® and tine con­
trol before you actually begin tilling.
• Start engine, tip tines off ground by
pressing handles down and engage tine
control to start tine rotation. Allow tines
to rotate for five minutes.
• Check tine operation and adjust if nec­
essary. See TINE OPERATION
CHECK” in the Sen/ice and Adjustments
section of this manual.
TILLING HINTS
A c AUHON: Until you are accustomed to
handling your tiller, start actual field use
with throttle in slow position {mid-way be­
tween “FAST and “IDLE").
To help tiller move forward, lift up the han­
dles slightly (thus lifting depth stake out of
ground). To slow doy\m the tiller, press
down on handles. ?
If you are straining or tiller is shaking, the
wheels and depth stake are not set prop­
erty in the soil being tilled. The proper set­
ting of the wheels and depth stake is
through trial and error and depends upon
the soil condition. (The harder or wetter
the ground, the slower the engine and tine
speed needed. Under these poor condi­
tions, at fast speed the tiller will run and
jump over the ground).
A properly adjusted tiller will dig with little
effort from the operator.
• Tilting is digging into, turning over, and
breaking up packed soil before planting.
Loose, unpacked soil helps root grovtrih.
Best tilling depth is 4“ to 6". A tiller will
also clear the soil of unwanted vegeta­
tion. The decomposition of this veg­
etable matter enriches the soil.
Depending on the climate (rainfall and
wind), it may be advisable to till the soil
at the end of the growing season to fur­
ther condition the soil.
• Soil conditions are important for proper
tilling. Tines will not readily penetrate
. dry, nard soil which may contribute to
excessive bounce and difficult handling
of your tiller. Hard soil should be mois­
tened before tilling; however, extremely
wet soil will “ball-up” or dump during till­
ing. Wait until the soil is less wet in order
to achieve the best results. When tilling
in the fall, remove vines and long grass
to prevent them from wrapping around
the tine shaft and slowing your tilling
operation.
• You will find tilling much easier if you
leave a row unfilled between passes.
Then go back between tilled rows. There
are two reasons for doing this. First,
wide turns are much easier to negotiate
than about-faces. Second, the tiller
won’t be pulling itself, and you, toward
the row next to it.
• Set depth stake and wheel height for
shallow tilling when working extremely
hard so ! or sod. Then work across the
first cuts at normal depth.
CULTIVATING
Cultivating is destroying the weeds
between rows to prevent them from rob­
bing nourishment and moisture from the
plants. At the same time, breaWng up the
upper layer of soil crust will help retain
moisture in the soil. Best digging depth is
1"to3".
• You will probably not need to use the
depth stake. Begin by tipping the depth
stake forward until it is held by the stake
spring.
• Cultivate up and down the rows at a
speed which will allow tines to uproot
weeds and leave the ground in rough
condition, promoting no further growth of
weeds and grass.
0 0 0 0
0
0 0 o 0 0
0 0 o o o
0 0 o o o
10