beautypg.com

Maintenance, A warning, A caution – Craftsman 921.166420 User Manual

Page 8: Storage, Maintenance schedule

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Maintenance

NOTE:

Any service procedure not covered in the

maintenance schedule should be performed by qualified
service personnel.

A WARNING

The air compressor should be turned off, unplugged from
the power source, air bled from the tank and allowed
time to cool before any maintenance is performed.

A WARNING

Do not attempt to remove or adjust the safety valve.

Maintenance Schedule

Items to Check/Change

Before each use

or daily

Check Tank Safety Valve

X

Overall Unit Visual Check

X

Drain Tank

X

Check Power Cord for Damage

X

Check the safety valve by performing these three steps:

1. Plug the compressor in and run until shut-off pressure
is reached.

2. Wearing safety glasses, pull out on the safety valve ring
to release pressure from the tank.
3.

The safety valve should close automatically at

approximately at 40-50 PSI. If the safety valve does not
allow air to be released when you pull out on the ring, or
does not close automatically, it must be replaced.

A CAUTION

To ensure efficient operation and longer life of the air
compressor unit, a routine maintenance schedule should
be followed. The following schedule is geared toward a
consumer whose compressor is used in a normal working
environment on a daily basis.

A CAUTION

This compressor is equipped with an automatic reset

thermal overload protector which will shut off motor if it

becomes overheated. If the thermal overload protector is

actuated, the motor must be allowed to cool down before

start-up is possible.

NOTE:

The motor will automatically restart without warn­

ing if the unit is left plugged in to an outlet with the Auto-

On/Off switch in the on position

Storage

For storing the air compressor, be sure to do the following:

1. Turn the unit off and unplug the power cord from the

receptacle.

2. Remove all air hoses, accessories, and air tools from

the air compressor.

3. Perform the daily maintenance schedule.

4. Open the drain valve to bleed all air from the tank.
5. Close the drain valve.
6. Store the air compressor in a clean and dry location.