Craftsman 315.212220 - Manual (Page 7)

UNPACKING
Your Compound Miter Saw has been shipped
completely assembled except for the accessories,
blade, miter lock handle, and dust guide or dust bag.
A. WARNING: If any parts are missing, do not
operate this tool until the missing parts are
replaced. Failure to do so could result in possible
serious personal injury.
■ Remove all loose parts from the carton. Separate
and check with the list of loose parts. See Figure 2.
■ Remove the packing materials from around your
saw.
■ Carefully lift saw from the carton and place it on a
level work surface. This saw is heavy. To avoid
back injury, get help when needed.
■ Do not discard the packing materials until you have
carefully inspected the saw, identified all loose
parts, and satisfactorily operated your new saw.
■ Your saw has been shipped with the saw arm
locked in the down position. To release saw arm,
push down on top of saw arm and pull out the lock
pin.
See Figure 4.
■ Hand pressure should remain on the saw arm to
prevent sudden rise upon release of the lock pin.
■ Examine all parts to make sure no breakage or
damage has occurred during shipping.
If any parts are damaged or missing, do not attempt to
plug in the power cord and turn the switch on until the
damaged or missing parts are obtained and are
installed correctly.
ACCESSORY LIST
The following accessories are included with your Compound Miter Saw:
Dust Bag
Table Extensions (2)
Stop Block
Small Wing Screw
Work Clamp Assembly
Clamp Extension Rod
Clamp Support
Clamp Bracket (2)
Clamp Bracket Screw (2)
Small Screw (4)
CLAMP SUPPORT SCREWS
WORK CLAMP
ASSEMBLY
DUST BAG
SMALL
WING SCREW
TABLE
EXTENSION
TABLE
EXTENSION
CLAMP
BRACKET SCREW