Accessories – Craftsman 315.212220 User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ACCESSORIES

CLAMPING WORKPIECE TO THE FENCE

■ Insert the grooved end of the clamp extension rod

as far as it will go into the front hole of the clamp
support. This will allow the clamp to press the

workpiece against the fence.

See Figure 44.

CLAMP WORKPIECE TO THE FENCE Fig. 44

■ Secure the clamp extension rod with a screw.

■ Slide the clamp assembly onto the clamp exten

sion rod and secure with a screw.

Note:

The clamp assembly can be slid forward or

backward on the clamp extension rod as
needed by ioosening the screw.

■ Turn the knob to secure and free the workpiece

against the fence.

■ Securely tighten all screws on the clamp before

each use.

■ Before making a cut, always check the blade and

blade guard clearance over and around the miter
clamp.

A WARNING:

Make sure the saw blade or blade

guard will not hit the work clamp assembly when
cutting miter and bevel cuts. Failure to heed this
warning could result in serious personal injury.

CLAMPING WORKPIECE TO THE SAW
TABLE

■ Insert the grooved end of the clamp extension rod

into the back, top hole of the clamp support. This

will allow the clamp to press the workpiece against
the saw table.

See Figures 42 and 45.

CLAMP

EXTENSION ROD

SCREWS

CLAMP SUPPORT

CLAMP WORKPIECE TO THE SAW TABLE

Fig. 45

■ Align the groove in the clamp extension rod with

the screw hole, and secure the rod with a screw.