Craftsman 917.271023 - Manual (Page 24)

BELT INSTALLATION -
• Install new belt In reverse order of
removal.
Mandrel
Pulley
• Make sure belt is |n all pulley grooves
and inside all belt guides.
• Install mower in reverse order of
removal instructions.
Idler
Pulleys
Mandrel
Pulley
TO ADJUST BRAKE
Your tractor is equipped with an adjustable
brake system which is mounted on the
side of the transaxle.
If tractor requires more than six (6) feet
stopping distance at high speed in high­
est gear, then brake must be adjusted.
• Depress clutchAirake pedal and engage
parking brake.
• Measure distance between brake oper­
ating arm and nut “A” on brake rod.
• If distance is other than 1-9/16", loosen
jam nut and turn nut “A” until distance
becomes 1-9/16". Retighten jam nut
against nut “A".
• Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than six (6) feet in highest gear,
further maintenance is necessary.
Contact your nearest authorized ser­
vice center/department.
Jam Nut
Nut “A”
Operating
Arm
Do Not touch this nut. If further brake adjustment is
necessary contact your nearest authorized service
center/department
24
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
• Remove mower (See “TO REMOVE
MOWER” in this section of this manual.)
• Remove belt from stationary idler and
clutching idler.
• Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over cool­
ing fan blades.
• Pull belt toward front of tractor and
remove downward from around engine
pulley.
• Install new belt by reversing above pro­
cedure.