Char-Broil 463270611 - Manual (Page 13)

2
1/4-20x1/2” screw
1
Attach side panels to bottom shelf using three
1/4-20x1/2” screws, 7mm lock washers, and
7mm flat washers per panel.
7mm lock washer
7mm flat washer
Place bottom shelf upside down. Insert Bent U Pin into the caster mounting plate to lock it in place, shown A.
Spin the caster clockwise into the threads on the bottom shelf until secure. Remove the Bent U Pin and repeat for remaining
casters. Make sure the two locking casters are secured at the rear and the non-locking casters are secured at the front.
After all 4 casters are secure remove the Bent U Pin and save for future maintenance.
Locking caster
Bottom shelf
Non-lock caster
Rear
Front
Left side panel
Magnet
(with a hole)
Make sure side panels
are pushed as far to the
rear of bottom shelf as
possible before fully
tightening screws.
Right side panel
ASSEMBLY
13
IMPORTANT: Panel with magnet must
be on left side of bottom shelf.
Front
Bent U pin
A