Assembly, Remove blower from carton, Assemble your unit into a blower or vacuum mode – Craftsman 358.798340 User Manual
Page 6: How to assemble your unit as a blower (fig. 1 ), Hardware contents assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HARDWARE CONTENTS
ASSEMBLY
REMOVE BLOWER FROM CARTON
• Remove loose parts included with Blower/vac.
• Remove all packing material.
• Check carton thoroughly tor additional loose parts.
ASSEMBLE YOUR UNIT INTO A
BLOWER OR VACUUM MODE
You can assemble your unit as a blower or a vacuum. Later
you can refer to these instructions and reconfigure your unit
into a different mode. The instructions below provide
information on how to assemble your unit for both
configurations.
HOW TO ASSEMBLE YOUR UNIT AS A
BLOWER (Fig. 1 )
If your unit is configured in the vacuum mode, turn the unit off
and disconnect it from the power source. Remove the
vacuum tubes and collection bag. Be sure to latch the inlet
cover closed.
ATTACHING THE BLOWER TUBE & NOZZLE
(Fig.2&3)
Remove the vacuum tubes and collection bag, if assembled
to the unit.
•
Insert the blower tube into the blower outlet.
• Turrt the blower tube clockwise until it is firmly seated in
the blower outlet.
• With a slight twisting motion, slide nozzle firmly into the
end of the blower tube.