Craftsman 315.212080 - Manual (Page 29)

MAINTENANCE
/k
WARNING: To ensure safely and reliability, all
repairs — with the exception of the externally
accessible brushes — should be performed by a
qualified service technician at a Sears store to
avoid risk of personal injury.
BRUSH REPLACEMENT
See Figure 35.
Your saw has externally accessible brush assemblies
that should be periodically checked for wear.
Proceed as follows when replacement is required:
■ Unplug your saw.
WARNING: Failure to unplug your saw could
result in accidental starting causing serious
injury.
■ Remove brush cap with a screwdriver. Brush
assembly is spring loaded and will pop out when
you remove brush cap.
■ Remove brush assembly.
■ Check for wear. Replace botii brushes when
ei№er has less than 1/4 in. length of carbon
remaining. Do not replace one side without
replacing the other.
■ Reassemble using new brush assemblies. Make
sure curvature of brush matches curvature of
motor and that brush moves freely in brush tube.
■ Make sure brush cap is oriented correctly
(straight) and replace.
■ Tighten brush cap securely. Do not overtighten.
29