Howto use your cleaning system, How to use the adjustable nozzle – Craftsman 580.768040 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

HOWTO USE YOUR CLEANING
SYSTEM
Read these instmctions and leam how to use your
cleaning system before you attempt to start your
cleaning system. If you have any problems operating
your cleaning system, please call the pressure washer
helpline at 1-800-222'3136.
How To Use the Adjustable Nozzle
A
WARNING! Never adjust spray pattern when
spraying. Never put hands in front of the nozzle
when adjusting the spray.
Push the nozzle fon/vard for low pressure. Pull the
nozzle backward until it “snaps" into place to
achieve high pressure.
Push
nozzle
forward
for low pressure.
Pull nozzle
backward for high
pressure.
Twisting the nozzle adjusts the spray pattern from a
narrow to a “fan" pattern.
Twist nozzle
clockwise for
narrow spray.
Twist nozzle
counterclockwise for
“fan" pattern.
•
For most effective cleaning, keep spray nozzle
between
8 to 24 inches away from cleaning
surface.
•
Damage to the surface may occur if you get spray
nozzle too close to it.
Cleaning With The Adjustable Nozzle and
Applying Chemical
IMPORTANT: Use soaps designed specifically for
pressure washer cleaning systems. Household
detergents could damage the pump.
WARNING! You must attach all hoses before
you start the engine. Starting the engine without
‘ all the hoses connected and without the water
turned ON will damage the pump.
A
Up to three,(3) different solutions can be carried on the
cleaning system at one time. To apply detergent follow
these steps:
• Dilution is necessary when using the supplied
chemical packets. Simply snip one comer of the
plastic pouch, pour the chemical into the tank, then
fill the tank with clean water. Label tanks with the
provided tank labels.
Pour chemical into one of
the tanks labeled A,B,C
If using another chemical designed for use wth
pressure washers, prepare the chemical solution as
required by the chemical manufacturer. Fill
chemical reservoir(s) with the prepared solution as
needed.
Rotate the Dial-A-Cleaner'''” selector knob to the
letter corresponding to the desired reservoir.
Push the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with nozzle
in high pressure position.
Review the use of the adjustabie nozzle.