Craftsman 917.272281 - Manual (Page 16)

NOTE: Before steuling, read the warm aixl
c(^ starting proceckjres bebw.
6. Insert key into ignition and turn key
clockwise to start position and release
key as soon as engine starts. Do not
run starter continuously for more than
fifteen seconds per minute. If the
engine does not start after several
attempts, push choke control in, wait a
few minutes and try again. If engine
still does not start, pull the choke
control out and retry.
WARM WEATHER STARTING {50" F and
above)
7. When engine starts, slowly push
choke control in until the engine
begins to run smoothly, if the engine
starts to run roughly, pull the choke
control out slightly for a few seconds
and then continue to push the control
in slowly.
• The attachments and ground drive can
now be used. If the engine does not accept
the bad, restart the engine and allow it to
warm up for one minute using the choke
as described above.
COLD WEATHER STARTING (50" F and
below)
7. When engine starts, slowly push
choke control in until the engine
begins to run smoothly. Continue to
push the choke control in small steps
allowing the engine to accept small
changes in speed and load, until the
choke control is fully in. If the engine
starts to run roughly, pull the choke
control out slightly for a few seconds
and then continue to push the control
in slowly. This may require an engine
warm-up period from several seconds
to several minutes, depending on the
temperature.
AUTOMATIC TRANSMISSION WARM UP
Before driving the unit in cold weather,
the transmission should be warmed up as
follows;
1. Be sure the tractor is on level ground.
2. Release the parking brake and let the
brake slowly return to operating
position.
3. Allow one minute for transmission to
warm up. This can be done during the
engine warm up period.
• The attachments can be used during
the engine warm-up period after the
transmission has been warmed up and
may require the choke control be
lied out slightly.
NOTE: If at a high attitude (above 3000
feet) or in cold temperatures (below 32 F)
the carburetor fuel mixture may need to
be adjusted for best engine performance
(see ‘TO ADJUST CARBURETOR" in the
Service and Adjustments section of this
manual).
PURGETRANSMISSION
CAUTION: Never engage or disengage
freewheel lever while the engine is
running.
To ensure proper operation and perfor­
mance, it is recommended that the
transmission be purged before operating
tractor for the first time. This procedure will
remove any trapped air inside the
transmission whbh may have developed
during shipping of your tractor.
IMPORTANT: Should your transmission
require removal for service or replace­
ment, it should be purged after reinstalla-
tbn before operating the tractor.
1. Place tractor safely on level surface
with engine off and parking brake set.
2. Disengage transmission by placing
freewheel control in disengaged
position (See TO TRANSPORT in
this section of manual).
3. Sitting in the tractor seat, start engine.
After the engine is running, move
throttle control to slow position.
Disengage parking brake.
4. Depress forward drive pedal to full
forward position and hold for five (5)
seconds and release pedal. Depress
reverse drive pedal to full reverse
position and hold for five (5) seconds
and release pedal. Repeat this
procedure three (3) times.
NOTE: During this step there will be no
movement of drive wheels. The air is
being removed from hydraulic drive
system.
5. Shutoff engine and set parking brake.
6. Engage transmission by placing
freewheel control in engaged
position (See TO TRANSPORT in
this section of manual).
7. Sitting in the tractor seat, start
engine. After the engine is running,
move throttle control to half (1/2)
speed. Disengage parking brake.
8. Drive tractor forward for approxi­
mately five feet then backwards for
five feet. Repeat this driving proce­
dure three times.
Your transmission is now purged and
now ready for normal operation.
16