Cobra Electronics COBRA XRS 9550G - Manual (Page 17)

English 28
GPS Settings
GPS Locator
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Nothing Comes Close to a Cobra ® 29
GPS Locator
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Visual Display
In addition to distance from the Location, the screen will show the type of alert.
PE
Photo Enforced Areas
CA
Caution Areas
SPEED TR UL
User Location
IntelliScope
IntelliScope adds direction information to the distance and type of Location-Based
Alert (other than Known Speed Trap Locations) by showing an arrow at the right of
the screen.
In zones 1 and 2 the arrow will point in the approximate direction of the Location. In
zone 3, the location is in front of you. The factory setting is IntelliScope On.
Display while approaching a Photo Enforcement Location on your route and
directly ahead.
NOTE The arrow disappears in Zone 3 when you are close to the Location.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Zone 1 Zone 2 Zone 3
IntelliScope Alert Signal For a Location Directly Ahead
PE PE PE PE PE
Display while approaching and passing a Caution Area that is some distance
away to the right of your route.
NOTE The signal never enters zone 3 since you never get close
to the Location.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
NOTE IntelliScope does not indicate the direction of Known Speed Traps.
Whenever you approach Known Speed Trap Locations, the warning
will scroll across the display.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Zone 1
IntelliScope Alert Signal Sequence When Location Is Off Your Route
CA CA CA CA CA
Display while approaching a Photo Enforcement Location involving a turn onto
a cross street where it is located.
NOTE The arrow changes to straight ahead after turning onto the cross
street where the Location is.
Intro Operation Customer
Assistance
Warranty
Notice
Main Icons
Secondary Icons
Zone 1
IntelliScope Alert Signal Sequence When You Turn Toward the Location
PE PE PE
Zone 3
PE PE
Vehicle Tur
ns Right
IntelliScope
(continued)
When IntelliScope is turned Off, Location-Based Alerts will be sounded only
when the Location is ahead of you and in the direction of your vehicle’s travel.
No arrow will be shown on the screen.
For example, if a particular red light camera operates only for vehicles going
north and your vehicle is going south, you will not receive an alert with
IntelliScope turned Off. With IntelliScope turned On, you will receive an alert at
that Location even though the camera does not operate in your direction.
To Turn IntelliScope Off and On
With the GPS Locator
connected and unit
power Off, press and
hold the IntelliMute
button. Then turn
the power On and
continue to hold the
IntelliMute button
for two seconds.
Tone Voice Visual Display
IntelliScope Off
= One beep
IntelliScope Off Intelliscope Off blinks
in the display
IntelliScope On
= Two beeps
IntelliScope On Intelliscope On blinks
in the display