Craftsman 315.111450 - Manual (Page 4)

IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER
1, SAVE THESE INSTRUCTIONS. This manual contains important safety and
operating instructions for battery charger Part Number 999555-007.
2 Before using battery charger, read all instructions and cautionary markings in this
manuai, on battery charger, and product using battery charger.
3 QEESS2S^° reduce risk of injury, charge only nickel-cadmium type rechargeable
batteries. Other types of batteries may burst causing personal Injury and damage.
4. Do not ekpose charger to rain or snow.
5. Use of an attachment not recommended or sold by the battery charger manufacturer
may result in a risk of fire, electric shock, or injury to persons.
6 To reduce risk of damage to charger body and cord, pull by charger body rather than
cord when disconnecting charger, *
7 Make sure cord is located so that it will not be stepped on, tripped over, or otherwise
subjected to damage or stress.
8 An extension cord should not be used unless absolutely necessary. Use of improper
extension cord could result In a risk of fire and electric shock. If extension cord
must be used, make sure:
a. That pins on plug of extension cord are the same number, size and shape as
those of plug on charger.
b. That extension cord is properly wired and in good electrical condition; and
c. That wire size is large enough for AC ampere rating of charger as specified
below:
AWG Size of Cord/Length of Cord, Feet
Feet
AWG 25
18 50
18
100
18
150
16
9 DO NOT OPERATE CHARGER WITH A DAMAGED CORD OR PLUG. If damaged,
have replaced immediately by a qualified serviceman.
10, Do not operate charger If it has received a sharp blow, been dropped, or otherwise
damaged in any way; take it to a qualified serviceman
11 Do not disassemble charger; take it to a qualified serviceman when service or repair
Is required. Incorrect reassembly may result in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet before attempting any
maintenance or cleaning. Turning off controls will not reduce this risk.
13. Do not use charger outdoors.
14. Disconnect charger from power supply when not in use.
^GAUTIDN:
Tha aperalton of any Powar Tool can resuil In loreign objacls being thrown Into
your eyaa, which can result In severe aye damage. Before commencing powar tool
operation, always wear safety goggles or safety glasses with side shields and a full
face shield when needed. We recommend Wide Vision Safety Mask for use over
spectacles or standard safety glasses with side shields, available at Sears Catalog
Orefer or Retail Stores.
Page 4