Operation – Craftsman 315.115042 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
SWITCH
An important new feature of your sander is the switch
design. It has multMinger control for use when operating at
different angles or sanding positions and to help reduce
fatigue.
It also has a lock-on feature in the switch for added utility
and convenience on extended work requirements.
Carefully read and understand the following instructions for
correct operation of the switch before connecting your
sander to power supply.
To Activate Switch:
To start your sander, depress the switch trigger and switch
actuator at the same time. See Figure 4.
Note; The parts of the switch can be easily identified by
their color. The switch trigger is red. The switch actuator is
black.
"LOCK-ON" FEATURE
■ Start your sander by depressing the switch trigger and
switch actuator.
■ Continue to hold your sander in the
ON
position with
your fingertips and release the switch trigger. See
Figures 5 and 6.
■ Release the switch actuator and grasp your sander by
the handle as shown in figure 7.
TO RELEASE "LOCK-ON" FEATURE
■ Depress the switch trigger and release it. See Figure 8.
A
WARNING:
Before connecting your sander to
power supply source, always check to be sure it is
not in "lock-on" position. Failure to do so could
result in accidental starting of your sander resulting
in possible serious injury. Also do not lock the
trigger on jobs where your sander may need to be
stopped suddenly.
DEPRESS SWITCH TRIGGER AND SWITCH ACTUATOR TO
START YOUR SANDER
^
STEP 1: DEPRESS SWITCH TRIGGER AND SWITCH
ACTUATOR WITH YOUR FINGEHTiPS
Fig. 6
STEP 3; GRASP BY HANDLE FOR SANDING WITH YOUR
SANDER IN "LOCK-ON" POSITION
Fig. 7
STEP 4; DEPRESS SWITCH TRIGGER TO RELEASE
"LOCK-ON" FEATURE
Fig. 8